As with the seat base the seat back on the Coupe had also had some previous “attention”
Once the cover and padding was removed the inspection began with a clean up
Once again the dangerous sharp fencing wire was removed and again a number of the springs were in need of repair
Again the springs were given the foam treatment after repair
An extra foam support was cut to sized and added to the top of the seat back for additional support for the springs at the top of the seat back
Webbing was also added for further support, belt and many braces!
The hessian base was then attached to the seat back springs using hog rings, along with the extra foam support.
The foam and wadding was then attached using hog rings and a little tape to keep the shape whilst the cover is being installed
The cover was then installed using hog rings as per the norm.
Some more foam was added to the he rear of the seat back before the vinyl on the trim was glued and refitted
The set back was then test fit into the Coupe.
Again this is how we did this and it worked for us!