Tag: electronic ignition

Tuning Up and Dialing In With an Upgraded Electronic Distributor – Terry McGean @Hemmings

Tuning Up and Dialing In With an Upgraded Electronic Distributor – Terry McGean @Hemmings


Electronic ignition systems were just coming online as the original muscle car era was fading out. The electronic triggering replaced traditional breaker points, eliminating a maintenance item while providing both more consistency and the ability to run a more powerful spark.

General Motors had offered “transistorized” ignitions on some models in the ’60s, but those systems were notoriously troublesome. However, during the 1974 model year, a new electronic ignition debuted on select GM models called High Energy Ignition, which would quickly come to be known as simply “HEI.” The new system became standard on all GM passenger car and light truck V-8 engines for 1975, and soon proved to require very little maintenance. The coil was located inside, under a cover at the top of the distributor cap, and the control module was mounted in the base so that the entire ignition system was contained in the distributor itself —only a single power feed wire was required.

Lurking back behind that Quadrajet on this stock 1985 GMC’s Chevy small-block V-8 is one of the familiar H.E.I. distributors. This was GM’s electronically triggered “High Energy Ignition” system that replaced traditional breaker points on virtually all GM passenger car and light truck V-8 engines for 1975. It is self-contained, easy to service, and quite reliable, but this one is now more than 35 years old.

Thanks to the new HEI’s high-powered spark and reliable performance, in addition to its plug-and-play arrangement, some enthusiasts began swapping the units into older models. Another benefit of the HEI was expanding dwell, a feature built into the control module. This means that as rpm increases, the duration of the spark also increases. The feature helps to yield more complete combustion for cleaner emissions, but it can also provide a boost to power output.

One downside of the HEI was that, since it came into being during the depths of the “smog” era, it was common for the factory advance curve rates to be very conservative, and not necessarily conducive to performance. Fortunately, these distributors can be recurved just like earlier breaker-point units. As the HEI made its way further into performance applications, another shortcoming revealed itself: The HEI’s output often begins to trail off after around 5,500 rpm. That’s the point where most factory engines of the time were reaching their maximum rpm, but obviously well short of the levels racing engines typically see.

Read on

Looks like she’s dead Jim…


A day after the trauma of the breakdown on the way to Wheels Day, the investigation began!

Still refusing to start and having no spark I decided to swap in a known good coil, lo and behold the car started and I was able to reverse out of the garage having to push in the day before.

After letting the car idle for about 10 mins it decided to cut out and refused to restart.

Knowing that the Pertronix is very sensitive to correct voltage I decided to charge the battery, however the car still failed to start and still had little or no spark.

So the decision to go back to points is confirmed and the parts are on order from O’Neills

What’s the point(s)!


After a few days preparation, a good road test and Simon’s assistance with clutch adjustment we were ready for our annual trip to Wheels Day in Aldershot, well we thought we were…

Things started to feel a little strange on the M4, but we put that down to a GAV adjustment as after a tweak things improved. However the car cut out and restarted after we came off the motorway, we managed to get around another couple of miles and then broke down with a bang and no restart this time. We had fuel but no spark, the Pertronix electronic ignition module had failed, this is the second such failure in the three years that I’ve had the car.

1 / 6

A very wise man named John Cochran did suggest that I stick to points a couple of years ago, I took the “if it ain’t broke” approach, well now it’s broke and I’ll be reverting to points!

Luckily my friend John Barron was travelling with me to the show, and his personal AA cover ensured we got home safely and very efficiently (thanks again John!)

Hats off to the the two AA staff that helped us today, customer service at its finest. Suffice to say I joined when I got home!